Live Chat Software
Live Chat Software
Ifloor.com, Flooring Retail, Tukwila, WA
Pro-Account Application   |   1-800-454-3941
Pro-Account Application   |   1-800-732-7102
Live Chat Software
OR CALL 1-800-735-2487

Taylor Adhesives MSDS Sheet

SECTION I IDENTIFICATION
Manufacturer’s Name: W.F. Taylor Co., Inc.
Address/Phone: 11545 Pacific Ave.
Fontana, CA 92337
951-360-6677

Emergency Phone No.: 800-535-5053
Manufacturer’s Code Identification: MS Plus
Product Class: MS Polymer-Resin Blend
Trade Name: MS Plus Wood Flooring Adhesive
Date Revised: 06/05/08

SECTION II HAZARDOUS INGREDIENTS
None per OSHA Regulation: 29 CFR 1910.1200
SARA Title III Section 313 Chemicals: None

NFPA HMIS
H = 1
F = 0
R = 0

SECTION III PHYSICAL DATA
Boiling Point: No Data
Lbs./Gal: 13.9-14.2
Evaporation Rate/Vapor Density: Low
Vapor Pressure: Low
Percent Volatile: 0 (by weight) 100% solids
Color: Off White
Odor: Mild
Grams V.O.C. per liter of material: Less than 0.50 grams

SECTION IV FIRE AND EXPLOSION HAZARD DATA
Flash Point, Pensky-Marin C.C.: NA
Auto Ignition Temperature, Degrees F: NA
LEL: NA UEL: NA
Extinguishing Media: Water spray, CO2, foam, dry chemical
Unusual Fire and Explosion Hazards: None Known
Special Fire Fighting Procedures: Use self-contained breathing
Apparatus and turn out gear. Water may be ineffective but should be used to keep the exposed containers cool.

SECTION V HEALTH HAZARD DATA
Symptoms of Over Exposure: Eyes: Vapor may cause irritation
Skin/Inhalation: May cause slight irritation
Ingestion: May cause vomiting. Symptoms may be the same as inhalation.

FIRST AID PROCEDURES:
Eyes: Flush with water.
Skin: Wash with soap and water.
Inhalation: Remove to fresh air. Administer oxygen if necessary.
Ingestion: If swallowed, call Physician.

SECTION VI REACTIVITY DATA
Stability: Stable
Conditions to avoid: Protect from freezing, excessive heat
Incompatibility/Materials to avoid: Metal salts may coagulate the product.
Hazardous decomposition products: Oxides of carbon, water, and organic compounds of unknown structures.
Hazardous polymerization: Will not occur.

SECTION VII SPILL OR LEAK PROCEDURES
Steps to Be Taken if Material is Spilled: Keep out of sewer systems to prevent blockage due to polymer deposits. Scrape up to collect and place into closed containers for disposal.
Waste Disposal: Abide by all Federal, State, and local regulations.

SECTION VIII SPECIAL PROTECTION INFORMATION
Respiratory Protection: NIOSH respirator if needed.
Ventilation: Local exhaust
Protective Gloves: Chemical resistant gloves, apron, coveralls and boots as necessary to prevent contact.
Eyes: Chemicals goggles or face shield.
Other Protective Equipment: If clothing becomes contaminated, remove and clean before wearing again.

SECTION IX SPECIAL PRECAUTIONS
Precaution for Handling and Storing: Protect against physical damage. Store in a cool, dry place (50-90 degrees F). Keep away from heat and sparks. Keep from freezing.

KEEP OUT OF REACH OF CHILDREN

www.wftaylor.com